MSW Motor technics GD2580-S Manuel D'utilisation page 36

Detect if the placed door section is leveled by measuring the distance between the
door upper line and the level reference line. Place appropriate shims at the lower end
to adjust the section to be in level position, or the door will not move up and down
smoothly. As illustrated in Fig.11:
level reference line
Fig 11
Second: Place the roller in the left vertical track and slide it to the bottom, put the
roller shaft into the left jamb bracket of the bottom section, secure the bottom jamb
brackets to the door section with self-drill screws (not less than 3 screws). Note:
Please assure that the left and right jamb brackets are at the same height. Finally, hook
the steel cable to the inside cylinder of the rivet on bracket as illustrated in Fig.12:
bottom jamb
bracket of door body
cable
roller drum
Fig. 12
Third: Put the rollers into the left and right vertical tracks and move them to the end
of the door panel, then put the rolling drum shaft through #1 roller hinge and fix the
roller brackets and hinges on the holes of door panel cap with self-drilling screws.
Please refer to Fig.13:
70
rolling drum
Fig. 13
5.2. Assembling the whole door sections
roller drum
roller drum
roller drum
roller drum
roller drum
Rev. 20.11.2017 Rev. 20.11.2017
hinge
bracket of
roller drum
block plate of
door section
Install the door panels like in Fig. 14 and install
#2, #3 and #4 roller hinges and top brackets
like in Fig. 15. Please ensure that the #2 roller
top bracket
hinges is installed between the second and
sliding plate
the third door panels. #3 roller hinges should
the top section
be installed between the third and the fourth
door panels respectively. If the door is rather
higher, you have to add #4 and #5 roller
hinges. In the middle of the door panels, you
only have to install the middle hinges. The
axes of the hinges should be parallel with the
bracket of rol-
door panel joints.
ler drum No.3
the third
section
bracket of rol-
ler drum No.2
the second
section
bracket of roller drum
No.1
bottom section
bottom jamb bracket
Fig. 14
71