Operating Instructions - Skil PWRCORE 12 ID6744A-00 Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATING INSTRUCTIONS

WARNING
fluid or allow a fluid to flow inside them. Corrosive or conductive fluids, such as seawater,
certain industrial chemicals, and bleach or bleach-containing products, etc, can cause a short
circuit.
WARNING
could result in serious personal injury.
WARNING
modification is misuse and could result in a hazardous condition leading to possible serious
injury.
WARNING
assembling parts.
This cordless impact driver must be used only with the battery packs and charger listed
below:
Battery Pack
2Ah
SKIL BY500101
SKIL BY519901
NOTICE: Please refer to the battery and charger manual for detailed operating information.
To Attach/Detach Battery Pack
(Fig. 2)
Lock the variable-speed trigger switch "OFF"
on the tool by placing the direction-of-rotation
(forward/center-lock/reverse) selector in the
center position before attaching or detaching
the battery pack.
To attach the battery pack:
Align the raised rib on the batter pack with the
grooves on the tool, and then slide the battery
pack onto the tool.
NOTICE: When placing the battery pack on the
tool, be sure that the raised rib on the battery
pack aligns with the groove inside the tool
and that the latches snap into place properly.
Improper attachment of the battery pack can cause damage to internal components.
To detach the battery pack:
Depress the battery-release button, located on the front of the battery pack, to release the
battery pack. Pull the battery pack out and remove it from the tool.
WARNING
be locked in center position when not in use or carrying at your side.
To reduce the risk of fire, personal injury, and product damage due to
a short circuit, never immerse your tool, battery pack or charger in
If any parts are damaged or missing, do not operate this product until
the parts are replaced. Use of this product with damaged or missing parts
Do not attempt to modify this impact driver or create accessories not
recommended for use with this impact driver. Any such alteration or
To prevent accidental starting that could cause serious personal
injury, always remove the battery pack from the impact driver when
4Ah
SKIL BY519801
Battery tools are always in operating condition. Therefore, the Direc-
tion-of-Rotation (forward/center-lock/reverse) Selector should always
Charger
SKIL QC535701
SKIL SC536501
Fig. 2
Detach
Battery-Release
Button
Attach
11

Publicité

Table des Matières
loading

Table des Matières