Publicité
Les langues disponibles
Les langues disponibles
Quick start guide, Frequency converter FU
for Schmalz Blower SB-V and SB-V1 / SGBL-FU
30.30.01.00055
The local operation of the device is done on the operating panel as shown.
Pressing the ▲ button increases the current nominal value; ▼ lowers it.
A malfunction can be acknowledged by pressing the button.
In normal operation the green LED chain indicates the magnitude of the currently set nominal value.
Every individual LED corresponds here to about 20% of the maximum settable value range.
If there is an error, then the green LED chain indicates the respective error code in combination with the
continuously lit red LED.
Table of possible error messages
Display
Technical specifications
Motor rated power
Mains voltage
Typical input current
Recommended mains fuse
Output voltage
Output continuous current
Seite / Page 17/24
Malfunction
Short circuit
Overvoltage Intermediate circuit
Undervoltage Intermediate circuit
Overtemperature motor
Mains interruption
Offset current sensor
Overtemperature Power output stage
Overcurrent
Inner temperature too high
Charge relay defective
I
*t limitation
2
Earth fault
Feldbus timeout
IO controller defective
RS485 timeout
Alarm 1 or 2 or 3
Alarm 1
Alarm 2
Alarm 3
Blocking
J. Schmalz GmbH
Aacher Straße 29
D - 72293 Glatten
Tel +49 +7443 / 2403 - 0
Fax +49 +7443 / 2403 - 259
Status 01.2014
http://www.schmalz.com
Index 01
e-mail: schmalz@schmalz.de
[kW]
[A]
surge-proof 16 A
[A]
FU
4,0
3 AC 400 – 480 V, ±10%, 47 ... 63 Hz
13.0
3 AC 0 V – mains voltage
9.5
Publicité
