Allmatic BIG 0.8 Mode D'emploi page 13

MOTOR AND RACK FITTING
The rack shall be fitted over the motor support, at a certain distance from It.
Its height can be adjusted thanks to the holes In the rack.
The height adjusting is necessary to prevent the gate leaning on the driving gear (5 and 6).
To fix the rack on the gate, drill some Ø 5 mm holes and thread them using an M6 screw tap.
The driving gear needs some 1 mm clearance from the rack.
Measurements in mm
LIMIT SWITCH FITTING
In order to determine the gate travel length, place two cams at the ends of the rack (7).
Move the cams on the rack teeth to adjust their opening and closing travel.
To fix the cams to the rack, tighten the screws issued.
N.B: In addition to the electric stop cams mentioned above, you must also install strong
mechanical stops preventing the gate from sliding out from the top guides.
MAINTENANCE
To be carried out exclusively by skilled persons after the power supply to the motor
has been interrupted.
Periodically, when the gate is standstill, clean and keep the guide free from stones and dirt.
DISPOSAL OF THE PRODUCT
This product is an integral part of the automation, and therefore, they must be disposed
of together. As for the installation operations, at the end of the life of this product, the
dismantling operations must be performed by qualified personnel. This product is made from
different types of materials: some can be recycled, others must be disposed of. Please inform
yourselves on the recycling or disposal systems provided for by the laws in force in your area,
for this category of product.
CAUTION! – some parts of the product can contain polluting or dangerous substances which,
if dispersed in the environment, may cause serious harm to the environment and human
health.
As indicated by the symbol at the side, it is forbidden to throw this product into
domestic refuse. Therefore, follow the "separated collection" instructions for
disposal, according to the methods provided for by local regulations in force,
or redeliver the product to the retailer at the moment of purchase of a new,
equivalent product.
CAUTION! – the regulations in force at local level may envisage heavy sanctions
in case of abusive disposal of this product.
6-1624010 rev.13
ITA ENG
11/12/2018
5
FRA ESP DEU POR
Measurements in mm
6
7
13/20