Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION AND ASSEMBLY
1.
Create a space in the wall for the single lever mixer and its plastic protective casing. (Fig.1)
2.
Lodge the cold water supply pipes to the lower right hand side, while the hot water pipes to
the left. In the upper part, position the sanitary supply pipe. (Fig.2)
3. To prevent impurities or debris from entering the mixer and causing operating
problems, flush out the system before connecting the supply pipers. The
installation of a special inflow filter is recommended.
4.
Place the single lever mixer complete with plastic protective casing, paying attention that the
surface level of the tiles-finished wall is within 45.5 and 70.5 mm. (Fig.3)
5.
Complete the connections as shown in Figure 4.
6.
Check the plant and verify the absence of any leak
7.
Clad the walls, see Fig. 5.
8.
Remove the plastic protection (Fig. 6).
9.
Remove any filth/impurities on the surface of the single lever mixer and/or tiles (Fig.7)
10. Remove the film from the sponge in the backside of the cover plate (6). Insert the plate on the
shaft sticking out of the concealed part of the mixer and push the plate against the wall (fig. 8)
11. Insert the mixing/on-off handle and (7) keeping the hole pointed upwards, as per figure 8.
Fasten the handle by the specific threaded pin (8) and insert the cap (9).
12. Clean the assembled product with care (Fig. 9).
11
Publicité
