Tectro TBH 460 Manuel D'utilisation page 92

4
92
man_TBH460 ('11).indd 92
d. nOrMaL OPeratiOn OF the stOVe
KEY P1 LED 1
KEY P2 KEY P3
• K ey P1: increase the by the user required room temperature. P1 can also be used
to show indication of the flue gas temperature and to show burning level.
• Key P2: decrease the by the user required room temperature.
• Key P3: enables possibility to change desired room temperature.
• Key P4: (ON-OFF) to turn on and off, to unlock from alarms.
• Key P5 and P6: to increase or decrease the heating power output level.
• Led 1: timer is activated
• Led 2: auger is activated.
• Led 3: receiving input from remote control.
• Led 4: thermostat indicator
• Led 5: setting temperature or inside setting menu.
• D isplay A: during starting it shows the stove state, during normal operation it
shows the heating power, when changing parameters it shows the parameter
subject to change.
• D isplay B: during starting it shows the stove state, during functioning it shows
the required room temperature desired by the user, during setting of inputs it
shows the parameter output.
d.1 cOntrOLLinG the stOVe
d.1.1. regular and non regular starting up procedure and operating mode
d.1.1.1 regular starting up procedure and operating mode
The normal start up and working procedure of the stove is as following:
1. Make sure the burning pot is empty and clean.
2. Make sure the fire door is closed.
3. Fill the fuel hopper with good quality wood pellets.
4. P ress key P4 for minimum 4 seconds until display shows "Fan Cand". The stove
is now in igniting pre ventilation phase which will last for approximately 2
minutes.
5. After the 2 minutes igniting pre ventilation phase the stove will start loading
pellets to the burning pot. The display will show "Load Wood". During this
phase the auger will transport pellets from the fuel hopper to the burning pot.
In the same time the ignitor will start heating the burning pot.
6. During this phase the heat in the burning pot will increase so much that the
fire will start.
7. The display will now show "Fire on".
DISPLAY A LED 2
DISPLAY B LED 4 LED 5
LED 3 KEY P6
KEY P4 KEY P5
07-10-11 09:06