Publicité
Les langues disponibles
Les langues disponibles
6. Insert the base of the riving knife into the clamp slot behind the blade as
shown (fig 4). The lock lever (a, fig 4) on the clamp slot should be
pointing up to allow the insertion.
7. When the riving knife is fully inserted and seated firmly, move the lock
lever 1/4 turn counter-clockwise (fig 5) to clamp it there.
8. Place the transparent guard assembly on top of the riving knife so that
the slot in the guard's aluminum support bar engages the two hooks
(h, fig 3) along the top edge of the knife, just ahead of the attachment
bracket (b, fig 3) for the anti-kickback pawls. You will have to loosen the
lock knob (k, fig 2) at the back of the guard assembly aluminum support
bar.
9. When the guard assembly is firmly hooked into the slot, re-tighten the
lock knob.
10. Should it be necessary during a particular cutting operation to
temporarily remove the anti-kickback pawls from the guard assembly,
they can be removed by pulling the lock pin (p, fig 3).
WARNING! Be sure to re-attach the pawls when your job is done.
11. Re-install the insert plate.
MOUNTING THE RIP FENCE
1. The fence is pre-assembled in the carton.
2. Hook the back of the fence over the rear edge of the table top.
3. Lower the front of the rip fence onto the front rail, with the fence lock
handle up. This allows it to slide along the rail. Pushing down on the
fence lock handle clamps the fence squarely into place.
4. Should it be necessary, the lock nut at the rear of the fence can be used
to increase or decrease the tension on the locking lever.
WARNING! Always ensure the rip fence is parallel to the saw blade
before use to avoid blade jam and timber kick back.
BLADE HEIGHT ADJUSTMENT HANDWHEEL
● This wheel adjusts the blade height.
● Turning it clockwise raises the blade, giving a deeper cutting depth.
● Turning counterclockwise reduces cutting depth.
● Before using, fit the handwheel handle to the front of the knob to give
you more accurate control.
CHECK THE BLADE
WARNING! First time use or after changing the saw blade. With the
machine DISCONNECTED from the power supply, rotate the blade
carefully by hand to ensure that nothing fouls its operation.
WARNING! Always disconnect the tool from power source before
making any adjustments, storing, servicing, or changing accessories.
Such preventive safety measures reduce the risk of starting the tool
accidentally.
8
Publicité
