Bosch HDC100 Consignes De Sécurité/D'utilisation page 9

2610048761.qxp_HDC100, 200, 250, 300, 400 10/25/17 1:47 PM Page 9
HDC100
USE WITH A DUST EXTRACTOR
(Not included)
Insert the dust extractor hose from the dust
extractor into the dust port of the dust extraction unit
(Fig. A14).
The Bosch dust extractor hose comes with a
sleeve nozzle attached to a snap-in connector (Fig.
A14). The sleeve nozzle provides the quickest,
easiest connection of the nozzle to the attachment.
The snap-in connector provides a more secured
connection. To use the snap-in connecter, remove
the rubber nozzle from the dust extractor hose.
Press the snap-in connector into the dust port until
you hear the click.
Dust port adaptors are also available to connect the
Bosch dust extraction attachment to any common
size dust extractor hose. See Boschtools.com for
details.
FIG. A14
Operating Instructions
SNAP-IN
CONNECTOR
DUST
SLEEVE
PORT
NOZZLE
CONNECTOR
Turn the dust extractor on and place the tool /
attachment over the desired drilling location so that
bit is lined up with the center of the hole to be
drilled. Follow all tool safety and operating
instructions.
Note: for best results, continue running the tool
even when removing the bit from the hole. The
combination of the vacuum with the spinning
motion of the bit helps remove a majority of the dust
from the hole.
The dust extractor must be suitable for the
material being drilled.
Following a few simple tips will reduce wear on
the tool and the chance of injury to the
operator.
DUST
EXTRACTOR
DUST
EXTRACTOR
HOSE
-9-