Bosch HDC100 Consignes De Sécurité/D'utilisation page 14

2610048761.qxp_HDC100, 200, 250, 300, 400 10/25/17 1:47 PM Page 14
HDC300
Chiseling only: The HDC300 is designed to
be used for chiseling in masonry and
concrete materials with either SDS-max or
Spline chisels.
The dust extraction attachment should be
positioned approximately 3" from the tip of
the bit for best dust extraction results (Fig.
C7). You can adjust the positioning of the
attachment by opening the clamping band
lever and sliding the attachment forwards or
backwards on the hammer tube.
extending the adjustment, the extension arm
can be moved forwards or backwards within
the clamping band mechanism. When
complete, close the clamping band lever to
re-secure the attachment to the tool
(Fig. C8).
For extra long chisels, the HDC300 comes
with an extension tube. Remove the rubber
bumper from the housing.
FIG. C8
Operating instructions
FIG. C7
For
extension tube by sliding the wide opening
onto the housing end. Re-install the rubber
bumper onto the tip of the extension tube
Install the
(Fig. C9).
RUBBER
BUMPER
-14-
EXTENSION
ARM