Operation; Before Starting The Machine; Starting The Machine - GÖLZ FS175 Mode D'emploi Et Liste Des Pièces De Rechange

FS175
valve (1) is closed (ball valve lever in 90° -position to
the water flow).
For cutting open the ball valve (1) (ball valve lever in
the water flow position).
4.

Operation

Information:
the owner's manual of the engine
manufacturer!
Danger: Never touch rotating parts
like blade
operating!
4.1

Before starting the machine

Check the machine for safe operating condition.
• All components must be properly mounted.
• The functions of the combustion engine must
function properly.
• Do not make any changes on operating
elements and safety devices.
The machine may only be operated in safe operating
condition.
Lock the push bars so that the machine can be
operated in a favorable posture.
If work is carried out where harmful or explosive
substances, such as dust, sludge occur, observe the
applicable national regulations.
If there is a risk that, during the cutting process,
material particles are accelerated outwards, wear
safety goggles.
Danger: Demolition parts can cause
injuries to the operator while cutting!
When travelling on public roads, ways and places
always observe the valid traffic regulations and, if
necessary, make sure beforehand that the machine is
in a condition compatible with these regulations.
After operating secure
unintentional moving.
Unconditional observe
shaft or blade while
the machine against
Danger: The sound pressure may
exceed 85 dB(A)!
Appropriate to the application of the machine it could
be necessary to wear further protective equipment.
Danger: Down coming parts at the
building site can cause injuries to the
operator!
The working area is reserved only for the operator.
Keep unauthorized persons out of the working area.
Make sure the operator always has well sight to the
working area. He always has to intervene in the
working process. Never operate the machine without
mounted safety devices.
Careless handling can lead to life-threatening injuries
caused by the rotating cutting disc. Only operate the
machine with fully mounted blade guard.
Nobody is allowed to remain in the working area nor in
the area where falling segments of the cutting disc can
be accelerated outwards (minimum safety distance
10m). If this safety distance cannot be respected, the
danger zone must be closed or be marked by warning
signs.
Care for the whereabouts of cooling and rinsing water
as well as of cutting sludge.
Cutting sludge must be collected, filtered and disposed
of.
4.2

Starting the machine

Danger: As soon as the combustion
engine is started, the cutting shaft,
respectively the cutting disc, starts
rotating too!
During cuts displace the machine
only with non-rotating blade (not
running engine)!
- 31-
1
3
5007287-01
BA-DE-GB-FR-NL
®
2