Comelit iPower kit Manuel Technique D'installation page 38

GROUP S.P.A.
• PUSHBUTTONS 2 - 3 - 4 - 5
Pushbuttons 2, 3, 4 and 5 may be all programmed
using the same procedure. The programming
procedure for pushbutton 2 is illustrated below.
From the installer menu (pushbutton 1), enter the
"Buttons programming" menu using
Select the "Program Button 2" icon using pushbuttons
and confirm your selection by pressing .
Select the desired function using pushbuttons
, confirm your selection by pressing
press button
MT KIT 12
38
and .
and then
.
If the "Intercom" function was selected in the
previous step, the pushbutton must be assigned to
an internal unit.
INTERCOM X (see paragraph 14 B).
GENERAL INTERNAL: Make a call to all monitors in
the same residential unit.
GENERAL EXTERNAL: Make a call to all monitors
in the other residential unit.
If the "Self-ignition" function was selected in the
previous step, the pushbutton must be assigned to
one or both of the internal units.
If the "Relay activation" function was selected in the
previous step, follow the procedure described for
Key pushbutton programming.
Press pushbutton to exit and save the changes.
Once you have completed the programming
procedures, disable the installer menu.