Franke FDW 908 IB XS Mode D'emploi Et Installation page 11

• Installation of the Motor Unit (1) at the front or rear must be de-
cided according to the position of the Kitchen unit, making sure
that the plug is properly positioned.
• Subsequently, according to where the air outlet opening has been
created on the unit, the Motor Unit can be turned by 90° at a time
so as to allow the air to come out on all 4 sides in correspondence
with the opening in Unit (2).
• Remove the Motor Unit from the support by
unfastening the 2 screws (A).
• Connect the connector from the Hood Canopy to
the Motor Unit connection.
• Replace the Motor Unit in the support using the
2 screws removed as described above.
• Screw the Motor Unit to the Hood Canopy using
the screws 12a and 12b provided as shown in the
figure.
EN
Fixing the Motor Unit
A
1 11