Measurement Menu - Fracarro KSTT Instructions D'emploi

The following is the COFDM (OUTPUT) menu in detail:
For the correct use, see paragraph 9 "INDICATIONS FOR PROGRAMMING".
OUTPUT FREQ. – sets the output frequency according to the channel (setting the country and the output chan-
nel) or according to the MHZ frequency (setting the bandwidth and the MHz frequency).
The following are the parameters that can be set from the OUTPUT menu of the COFDM modulation. FEC – sets
the parameter relevant to FEC (Forward Error Correction) among the possible choices (1/2, 2/3, 3/4, 5/6, 7/8).
GUARD INTERVAL – sets the guard interval among the possible choices (1/4, 1/8, 1/16, 1/32).
CARRIERS NUM. – sets the number of carriers between 2K and 8K.
CONSTELLATION – sets the constellation, QPSK, 16QAM or 64QAM, with which the carriers are modulated.
SPECTRUM – regulates the spectrum as NORMAL or REVERSED according to the reception instrument that
might work only in one of the two modes. Usually the "NORMAL SPECTRUM" setting is used.
LEVEL – regulates the output level on a scale between 0 and 15 to which a STEP equal to 1dB corresponds. Set-
ting the level to OFF, the output signal is disabled. The OFF output level can be set only during the normal opera-
tion and not when the SINGLETONE function is activated.
SINGLETONE – allows the use of a single tone at the input to facilitate the measurement of the output level. When
the SINGLETONE function is activated, no other channels can be inserted.
MEASURES
Information about bitrate
of transmitted channel
Information about
temperature

8.7 MEASUREMENT MENU

SOFTWARE VERS.
BER
S/N (IN) (dB)
BITRATE
TEMPERATURE
Confirm the settings by pressing the
pressing the S key after the modules programmation.
KSTT v. 0
Read-only
Read-only
Measurement of used bitrate
BITRATE USED
Measurement of avalilable
BITRATE AVAIL.
Measurement of the
BR. USED PEAK
peak of used bitrate
Measurement of the
BR. AVAIL. PEAK
peak of available bitrate
RESET BR. PEAKS Reset of the bitrate
OVERFLOW ALARM
TEMP. MOD. CORE
OVERTEMP ALARM
key; save the settings by
25
Read only
bitrate
peaks
RESET ALARM
NORMAL Read only
RESET ALARM