Whirlpool AWG812/PRO Consignes D'installation Et Sécurité page 30

For washing machines with
fitted plug, if the plug is not
suitable for you socket outlet,
contact a qualified technician.
Do not use extension leads,
multiple sockets or adapters.
Do not connect the washing
machine to a socket which can
be operated by remote control.
Do not pull the power supply
cable.
If the power cable is damaged
it must be replaced with an
identical one. The power cable
must only be replaced by a
qualified technician in
compliance with the
manufacturer instruction and
current safety regulations.
Contact an authorized service
centre.
Do not operate this washing
machine if it has a damaged
mains cord or plug, if it is not
working properly, or if it has
been damaged or dropped. Do
not immerse the mains cord or
plug in water. Keep the cord
away from hot surfaces.
The electrical components
must not be accessible to the
user after installation.
Do not touch the washing
machine with any wet part of
the body and do not operate it
when barefoot.
ELECTRICAL CONNECTION
FOR GREAT BRITAIN AND
IRELAND ONLY
Fuse replacement
If the mains lead of this
washing machine is fitted with
a BS 1363A 13amp fused plug,
to change a fuse in this type of
plug use an A .S .T .A . approved
fuse to BS 1362 type and
30
proceed as follows:
1 .Remove the fuse cover (A)
and fuse (B).
2 .Fit replacement 13A fuse
into fuse cover.
3 .Refit both into plug.
Important:
The fuse cover must be refitted
when changing a fuse and if
the fuse cover is lost, the plug
must not be used until a
correct replacement is fitted.
Correct replacement are
identified by the colour insert
or the colour embossed in
words on the base of the plug.
Replacement fuse covers are
available from your local
electrical store.
For the Republic of Ireland
only
The information given in
respect of Great Britain will
frequently apply, but a third
type of plug and socket is also
used, the 2-pin, side earth type.
Socket outlet/plug (valid for
both countries)
If the fitted plug is not suitable
for your socket outlet, contact
After-Sales Service for further
instruction. Do not attempt to
change the plug yourself .This
procedure needs to be carried
out by a qualified technician in
compliance with the
manufacturer's instructions
and current standard safety
regulations.
CORRECT USE
After the installation of the
washing machine has been
completed, remove the
transport bolts before using
the appliance.
Do not exceed the maximum
load allowed. Check the
maximum load allowed in the
programme chart.
Turn off the tap when not in
use.
If the washing machine
appears to be damaged,
contact the appliance owner
or, if necessary, the After Sales
Service.
CLEANING AND
MAINTENANCE
The washing machine must be
disconnected from the power
supply before carrying out any
cleaning or maintenance
operation.
Disconnection from the mains
must be permanently
controllable from each side of
the washing machine. Make
sure that the appliance is not
plugged in accidentally during
maintenance actions.
For cleaning or maintenance,
disconnection from the mains
must be permanently
controllable from each side of
the washing machine.
Never use steam cleaning
equipment.