Renson Cube TouchDisplay Manuel D'instruction Pour L'utilisateur page 132

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Remarks on programming the secondary control
• The CO
threshold needs to be deactivated on the secondary control.
2
(see section 9: 'Setting the CO
• When a control is programmed as secondary control, it is no longer possible to configure
any program points on this control.
• No program point is displayed on the secondary control when the main modes(AUTO –
MAN) are activated. There is no visible difference when the secondary modes (BOOST) are
activated.
• Errors are not displayed on the secondary control.
EN
132
• Select "Main Controller" with
• By using
or
control (= Main Controller: OFF). Confirm by pressing
will return into the INSTALLER MENU – DEVICE SETTINGS.
• Press shortly on both
To then exit the USER MENU as well, again press both
AND
.
Threshold')
2
n
.
you can set the TouchDisplay as secondary
AND
to exit the INSTALLER MENU.
n
. You

Publicité

Table des Matières
loading

Produits Connexes pour Renson Cube TouchDisplay

Table des Matières