Renson Cube TouchDisplay Manuel D'instruction Pour L'utilisateur page 109

• Exposure to radio waves.
The TouchDisplay contains a radio transmitter and receiver.
When activated, the TouchDisplay transmits and receives radio waves through the antenna.
• Do not install the TouchDisplay in rooms where it can be exposed to the following
conditions:
– A greasy atmosphere
– Corrosive or flammable gasses, fluids or vapours
– Room temperatures above 40°C or lower than -5°C.
– Relative humidity higher than 90%
– Areas where it could be exposed to water
Never submerge the TouchDisplay in water.
• Always take the following safety regulations into consideration when installing the
TouchDisplay. Non-compliance can result in damaging the appliance or in personal injury.
RENSON cannot be held accountable in such situations.
®
– Make sure that the electric power supply is 230V, 1 phase, 50Hz.
– The installation has to be performed in accordance with the general and local construc-
tion safety and installation regulations.
– The appliance needs to be installed in a way that prevents accidental contact. This
means that under normal circumstances nobody should be able to come in contact with
components under tension.
EN
109