Renson Cube TouchDisplay Manuel D'instruction Pour L'utilisateur page 115

Briefly push on the button KNX / LINK on the PCB of the Cube. The green LED above the button
wil now start to blink. Now continue by pressing
An extra line appears at the bottom of the display: "Linking".
XVKS Sensoren
– After a successful linking procedure the TouchDisplay switches
automatically to the main control menu. The TouchDisplay is now
ready for use.
– The following screen appears if the link is not established:
Repeat the procedure in case of a "failed" notification.
Remark:
The unit and TouchDisplay stay linked even after a power failure.
n on the TouchDisplay.
0-10V Fan control
Main 230V~
Fan power 230V~
11:38
1
EN
115