Before Starting Up The Equipment; Operation - EINHELL TE-CI 18/1 Li Traduction Du Mode D'emploi D'origine

The maximum screw diameter indicates the
maximum diameter of the screw that can be
screwed into wood. The screw diameter can vary
depending on the type of wood.
Wear ear-muff s.
The impact of noise can cause damage to
hearing.
Reduce noise generation and vibration to a
minimum!
•
Use only equipment that is in perfect
condition.
•
Maintain and clean the equipment regularly.
•
Adapt your way of working to the equipment.
•
Do not overload the equipment.
•
Have the equipment checked if necessary.
•
Switch off the equipment when not in use.
•
Wear gloves.
CAUTION!
Residual risks
Even if you use this electric power tool in
accordance with the instructions, certain
residual risks cannot be eliminated. The
following hazards may arise in connection
with the equipment's construction and
layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear
protection is applied.
3. Health damage caused by hand-arm
vibrations if the equipment is used over a
longer period or is not properly guided and
maintained.
Limit the operating time.
All stages of the operating cycle must be
considered (for example, times in which the
electric tools are switched off and times in which
the tool is switched on but operates without load).
Caution:
The metal gear head can become hot during
extended operation.
Anl_TE_CI_18_1_Li_SPK7_USA.indb 12 Anl_TE_CI_18_1_Li_SPK7_USA.indb 12
EN

5. Before starting up the equipment

Please read the following information before you
start using the cordless impact screwdriver for the
fi rst time.
1. Charge the battery pack with the charger
supplied.
2. Only use screwdriver bits that are suitable for
the task and in perfect condition.
3. Before screwing into in walls and masonry,
check for concealed electric wiring, gas pipes
and water pipes.

6. Operation

6.1 Charging the Li battery pack
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.2 Changeover switch (Fig. 2 / item 3)
The sliding switch above the On/Off switch is for
setting the direction of rotation of the cordless
screwdriver and for preventing the cordless
screwdriver from being switched on inadvertently.
You can select between clockwise and counter-
clockwise rotation. To avoid causing damage to
the gearing, the direction of rotation must only be
changed when the equipment is at a standstill.
When the slide switch is in the middle position,
the On/Off switch is blocked.
6.3 On/Off switch (Fig. 2 / item 4)
Infi nitely variable speed control is possible with
the On/Off switch. The further you push the
switch, the higher the speed of the cordless
screwdriver.
Switching on:
Press the On/Off switch (4).
Switching off :
Release the ON/OFF switch (4).
- 12 -
23.01.2019 11:09:28 23.01.2019 11:09:28