Technical Data; Before Starting Up The Equipment; Operation - EINHELL TE-CW 18 Li BL Traduction Du Mode D'emploi D'origine

4. Technical data

Motor power supply: ............................18 V
No load speed: ....................... 0-2900 rpm (min
Impacts per minute: .................0-3000 ipm (min
Torque: ............................... 1770 in-lbs (200 Nm)
Square drive: ...................................... ½" (13 mm)
Drill bit/socket adapter: .................. ¼" (6.35 mm)
Weight (Tool only): ...................... 2.42 lbs (1.1 kg)
Wear ear-muff s.
The impact of noise can cause damage to
hearing.
Reduce noise generation and vibration to a
minimum!
•
Use only equipment that is in perfect
condition.
•
Maintain and clean the equipment regularly.
•
Adapt your way of working to the equipment.
•
Do not overload the equipment.
•
Have the equipment checked if necessary.
•
Switch off the equipment when not in use.
•
Wear gloves.
CAUTION!
Residual risks
Even if you use this electric power tool in
accordance with the instructions, certain
residual risks cannot be eliminated. The
following hazards may arise in connection
with the equipment's construction and
layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear
protection is applied.
3. Health damage caused by hand-arm
vibrations if the equipment is used over a
longer period or is not properly guided and
maintained.
Limit the operating time.
All stages of the operating cycle must be
considered (for example, times in which the
electric tools are switched off and times in which
the tool is switched on but operates without load).
Anl_TE_CW_18_Li_BL_USA_SPK7.indb 12 Anl_TE_CW_18_Li_BL_USA_SPK7.indb 12
EN

5. Before starting up the equipment

Please read the following information before you
start using the cordless impact driver for the fi rst
)
-1
time.
)
-1
1. Charge the battery pack with the charger
supplied.
2. Only use screwdriver bits that are suitable for
the task and in perfect condition.
3. Before screwing into in walls and masonry,
check for concealed electric wiring, gas pipes
and water pipes.

6. Operation

6.1 Charging the Li battery pack
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.2 Changeover switch (Fig. 2 / item 4)
The sliding switch above the On/Off switch is for
setting the direction of rotation of the cordless
driver and for preventing the cordless driver
from being switched on inadvertently. You can
select between clockwise and counter-clockwise
rotation. To avoid causing damage to the gearing,
the direction of rotation must only be changed
when the equipment is at a standstill. When the
slide switch is in the middle position, the On/Off
switch is blocked.
6.3 On/Off switch (Fig. 2 / item 5)
Infi nitely variable speed control is possible with
the On/Off switch. The further you push the
switch, the higher the speed of the cordless
screwdriver.
Switching on:
Press the On/Off switch (5).
Switching off :
Release the ON/OFF switch (5).
- 12 -
30.09.2020 13:00:31 30.09.2020 13:00:31