Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
1
2
3
4
5
(KDC-X896, KDC-BT852HD only)
10 | Quick Start Guide
Before installation
2 WARNING
• The unit can only be installed in a car with
a 12V DC power supply, negative ground.
.....1
• If you connect the ignition wire (red)
and the battery wire (yellow) to the car
chassis (ground), you may cause a short
circuit, that in turn may start a fire. Always
connect those wires to the power source
running through the fuse box.
.....2
CAUTION
¤
• Install this unit in the console of your
vehicle.
• Do not touch the metal parts of this unit
.....4
during and shortly after use of the unit.
Metal parts such as the heat sink and
enclosure become hot.
• Mounting and wiring this product
requires skills and experience. For safety's
.....4
sake, leave the mounting and wiring work
to professionals.
• If you experience any problem during
installation, consult your Kenwood dealer.
• Disconnect the battery's negative terminal
before installing the unit.
.....1 (3m)
• Insulate unconnected wires with vinyl
tape or other similar materials. To prevent
a short circuit, do not remove the caps on
the ends of the unconnected wires and
terminals.
• Be sure to ground this unit to the car's
chassis again after mounting.
• If the fuse blows, first make sure the wires
are not touching other parts to cause a
short circuit, and then replace the old fuse
with one with a new the same rating.
• When connecting only two speakers,
connect the connectors either to both
of the front output terminals or to both
of the rear output terminals (do not mix
front and rear terminals). For example, if
you connect the + connector of the left
speaker to a front output terminal, do
Publicité
Chapitres
Table des Matières
