Reloop Spin! Mode D'emploi page 92

5.9 Why are both tracks being played on the same channel?
Both players are routed to the same OUT PORT. In the Info Screen, click on the
number after „Out Port" to change the routing. Typically you will want to route
the left channel to Port 1 and the right one to Port 2.
5.9.1 Why is there no signal?
There are several possibilities, please check the following:
•
•
•
•
•
•
•
•
5.9.2 Can I use the interface as a sound card?
You can use the Spin! interface as a mobile USB sound card with two stereo
inputs and two stereo outputs. Also it features a microphone input with
adjustable gain. If you use the mic input it will work instead of stereo input 1.
5.9.3 What do I have to observe if I use a Shure M44-7?
This cartridge will need a phase inversion. Go to „File -> Options -> Timecode"
and tick the box next to „Phase Inverse".
5.9.4 Why is the music skipping a beat now and then?
The cause may be a hard disc that is too slow. One solution is to set the setting
"Load Tracks to RAM" to "rapid" under "options>system". Furthermore it is
recommended to defragment the hard disc where the tracks are stored in order
to optimize the reading abilities.
5.9.5 Why does the speed / the pitch of my tracks fluctuate?
There are several reasons for this:
•
•
•
•
•
5.9.6 Is there an auto mix/party mix function?
Yes. Add some tracks to the Spin! list (NOT the Spin! library) and select „play
Spin! list" by right-clicking into the list. The tracks will be played alternately
between both players.
92
Is your mixer/amp turned on? Are gain, line and master controls turned up?
Did you choose the correct input on your mixer (phono instead of line)?
Is vinyl control activated? (Button „Vinyl" below the Label monitor has to be
green)
Is Spin! correctly configured?
Have all the cords been plugged correctly?
Does Spin! recognize the timecode?
Is a microphone plugged in? Unplug the mic, it blocks Input 1.
Is the correct Out Port set? Left Player: Out Port 1, right player: Out Port 2.
Spin! is not calibrated
the neddle is dirty/ dusty
there is too much weight on the needle
the needle is worn out
the timecode vinyl is worn out (scratches, cue burn) or dirty