Reloop Spin! Mode D'emploi page 53

a) Connect your turntable's or CD player's outputs to the corresponding inputs
(1 or 2) of the Reloop Spin! interface -1-. If required connect your turntables
to the GND grounding screw -3-.
b) Connect the line outputs of the Reloop Spin! interface to the line inputs of
your mixer -2-.
c) Connect the Reloop Spin! Interface to your computer via a free USB port.
Now the following messages should appear on your monitor (example for
XP):
New hardware found –
Reloop Spin! Interface
New hardware found –
USB audio device
New hardware found –
Your new hardware is installed and ready to use.
NOTE!
The installation of your Spin! interface under Windows XP & Vista is carried
out Plug 'N' Play without the need for special drivers.
d) After the system has recognized and installed your Spin! interface you
should maximise the volume in the Windows audio settings.
Example Windows XP:
start > control panel > sounds and audio devices > rider „audio"
53