Reloop Spin! Mode D'emploi page 54

Click on „Volume" under the item „Sound Playback" and maximise all faders.
The option „Sound Recording" for a
vinyl record or CD setup differ.
1) Vinyl settings
2) CDJ settings
Afterwards you can close the control panel.
e) Additional functions and connections of your Spin! interface:
54
Click on the „Sound Recording"
button and maximise the fader.
Click on the „Sound Recording"
button and minimise the fader.
USB LED -4-:
Shines when the interface has been recognized by the computer and is
active.
NOTE!
The interface is supplied with power via USB. A connection to mains is
not necessary.
Headphones -5 / 6-:
Here you can connect headphones (3,5 mm jack) in order to be able to
monitor the master output signal directly from the interface -5-. Via the
monitor knob -6- you can adjust the volume.
NOTE!
You can also use this output as recording connection in order to record
a set for example.
Microphone -7 / 8-:
You can connect a microphone to this jack (6,3 mm jack). The volume can be
adjusted with the knob -8-.
ATTENTION!
The microphone input is linked to the stereo output. This means you can
either use a microphone or the channel 1 signal. Make sure that no
microphone is connected during normal Spin! timecode use as the
channel would be blocked.
1) 2)