Manual Station Preset - Yamaha R-S300 Mode D'emploi

FM/AM TUNING

Manual station preset

You can manually register up to 40 FM/AM stations (40
total). You can then easily recall any preset station by
selecting its preset number.
y
When stations are registered manually, the FM Mode setting
(mono or stereo) at the time of registration is also registered.
Confirm the FM Mode setting (see page 18) before registering
stations manually.
MEMORY
RETURN
20
En
PRESET j / i
PRESET j / i
1
Tune in to the desired FM/AM station.
See pages 17 and 18 for tuning instructions.
2
Press MEMORY on the front panel.
"MANUAL PRESET" is displayed briefly on the
front panel display, and then the preset number to
which the station will be registered is displayed.
y
By holding down MEMORY on the front panel for more than 2
seconds, you can skip the following steps and automatically
register the selected station to an empty preset number (i.e., the
preset number following the last preset number used).
3
Press PRESET j / i on the front panel (or
PRESET j / i on the remote control) to select
the preset number to which the station will
be registered.
When you select a preset number to which no station
is registered, "EMPTY" is displayed. When you
select a preset number to which a station has already
been registered, the frequency of the station is
displayed.
Preset number
4
Press MEMORY on the front panel.
When registration is complete, the display returns to
the original state.
y
To cancel registration, RETURN on the remote control or do not
perform any operations for about 30 seconds.