Adjusting The Display; Factory Presets, Auto-Sync, And User Settings; On Screen Display (Osd) Settings - Wacom DTF-521 Guide D'installation Et Manuel D'utilisation

ADJUSTING THE DISPLAY

FACTORY PRESETS, AUTO-SYNC, AND USER SETTINGS

Factory presets: For optimal display quality, set your video card to the DTF-521's native resolution of
1024 x 768 pixels. See page 49 for signal specifications.
Auto-sync: The DTF-521 attempts to automatically synchronize to the incoming signal. Auto-sync will
function when the horizontal frequency is between 30 to 57 kHz and the vertical frequency is between
45 to 70 Hz for XGA mode, or 45 to 75 Hz for other modes. If the DTF-521 does not automatically
synchronize with the incoming signal, you can use the On Screen Display (OSD) R
option to initiate display synchronization. Further screen display adjustments can be manually made
using the OSD controls.
User settings: When you manually set the display using the OSD function, the settings are stored
within the DTF-521 for use the next time the unit receives a similar signal. This is applicable to all
display modes.

ON SCREEN DISPLAY (OSD) SETTINGS

The OSD function enables you to adjust and optimize a variety of display settings at the touch of a
button. The OSD controls are located on the upper left edge of the unit.
M button
ENU
Opens or closes the OSD menu.
The basic process for working with the OSD is as follows:
•
Press the M
ENU
•
Use the + or – buttons to select an option. When the option you want to adjust is highlighted,
press the E
NTER
•
Use the + or – buttons to adjust the option settings.
•
After making your changes, press the E
Note: All settings are automatically saved when the OSD menu closes. If you make changes to the display
appearance and cannot return to the original settings, use the
its original factory defaults.
button to open the OSD main menu.
button. The current settings and adjustment sub-menu for that option will appear.
– +
Selection buttons
Use these buttons to select an option that can be activated
when you press the E
NTER
option, press the + button to increase a selected item value,
and press the – button to decrease it.
button to save. To exit, press the M
NTER
R
ESET
ESET
E button
NTER
Activates or deactivates the
selected OSD menu option.
button. After activating a selected
ENU
R
option to return the DTF-521 to
ECALL
A A
UTO DJUST
button.
Customizing
Page 27