Troubleshooting - Schneider GROOVE CINEMA Manuel D'utilisation

11. Troubleshooting

In the unlikely event of difficulties with your appliance please follow the trouble
shooting guide below.
PROBLEM
No Power
No Sound
No response from
the unit
Remote control
does not work
Unit powers off
after 20 minutes
Remark: Watt-peak measurement is obtained by multiplying the continuous average power (RMS)
by 2 times the square root of 2 and rounding up the result by the nearest 5 or 0 digit.
SAV
ADMEA/LOGISAV
ZI du clos des charmes
26 rue du clos des charmes
77090 COLLEGIEN-FRANCE
POSSIBLE SOLUTION
 Ensure the mains plug is connected to a power supply,
and is switched ON.
 Make sure there is power to the mains socket.
 When playing from the AUX input, Make sure the
external source has the volume turned up and is playing
a track.
 Make sure the volume is turned up.
 If using the digital coaxial or optical cable connection
ensure the source DIGITAL output is set to PCM, LPCM,
PCM 2Ch stereo or PCM downmix.
 Bluetooth device not paired. Refer to "Bluetooth
operation".
 Unplug the power cable for 1 minute then plug back in
again.
 Reduce the distance between the remote and main unit.
 Check the batteries are installed correctly.
 Replace the batteries.
 Aim the remote directly at the Sound bar
 This unit is designed to enter STANDBY mode
automatically after 20 MINUTES of inactivity. Press the
STANDBY button to wake the unit.
- 33 -