Bluetooth Operation - Schneider GROOVE CINEMA Manuel D'utilisation

NOTE: When switching inputs there will be a 5 second pause after selecting BT
while the unit scans for paired devices.
Adjusting the volume level
Press the VOLUME+/- button repeatedly to increase or decrease the volume level.
Sound effect presets
During playback, press the SOUND EQ button repeatedly to change the sound
modes between STANDARD and MOVIE.
NOTE: When you select a sound mode, an audible message will follow to confirm
the mode you selected.
Bass enhancement
Press Bass+/- to strengthen or lower the level of Bass.
Mute function
1. Press the MUTE button on the remote will temporarily silence the audio output.
2. Press the MUTE button again to resume the audio output.
NOTE: The LED indicator will blink in RED to indicate the mute function is active.
Disable the Audible Message
Follow the steps below in order to disable the audible message.
1. Press STANDBY button to switch to STANDBY mode.
2. Press and hold
NOTE: Repeat the step 1 and 2 to activate the audible message.

8. Bluetooth operation

Pairing a Bluetooth device
Before you can use the sound bar with your phone or other Bluetooth capable device
you will need to pair the device to the sound bar.
1. Press SOURCE button repeatedly until you see the LED indicator turns blue,
and then stay flashing when no other devices paired.
2. Enable the Bluetooth function on your smart phone and search for a device
labelled "SC200SND" in the available list.
3. Select and enable pairing for the device "SC200SND". If prompted for a
password, enter "0000".
4. If pairing is successful the sound bar will beep and indicator stops flashing.
5. If the connected device goes out of range, the sound bar will attempt to
connect for 2 minutes. When the device comes into range the sound bar will
reconnect again automatically.
6. To remove the currently paired device, press and hold
remote control for 5 seconds. The indicator will begin flashing again.
button for 5 seconds.
- 29 -
button on the