TURNING THE POWER ON/OFF
When shooting pictures
Power on: Open the lens barrier fully.
The camera turns on in the shooting mode. The lens extends
and the flash pops up.
If the lens does not extend when the lens barrier is opened, there
is a possibility that the cover is stuck in the first click position.
Open the lens barrier until it clicks.
Power off: Close the lens barrier slightly until it almost touches the
lens barrel.
The lens barrier stops just before it touches the lens and the lens
retracts. Wait until the lens is fully retracted before closing the
lens barrier completely.
The camera turns off. (The monitor also turns off.)
Press the flash down until it locks into place to close it.
Do not push the lens barrier forcefully against the lens as this may damage
the lens or cause it to malfunction.
Diopter adjustment dial
Turn the diopter adjustment dial until
the AF target mark is clearly visible.
AF target mark
En 11
En