Ports - Abus IPCB42501 Manuel Utilisateur Logiciel

Select NIC:
NIC type:
DHCP:
Static IP address:
IP address:
Subnet mask:
Gateway:
IPv6 mode:
IPv6 address:
IPv6 Subnet Mask:
IPv6 Default Gateway:
MAC Address:
MTU:
Multicast address:
Enable multicast:
Preferred DNS Server:
Alternate DNS Server:

7.5.2.2 Ports

HTTP port:
RTSP port:
HTTPS port:
SDK port:
choose whether the LAN or WLAN interface (if available) should be
configured.
selection of the speed for the LAN adapter.
the IP address, subnet mask, gateway (default router) and address for
the DNS server are obtained automatically from a DHCP server. An
activated DHCP server must be present in the network in this case.
The fields on this page are deactivated in this mode and serve as
informational fields for the data obtained. If DHCP is not enabled, then
a static IP address is used (see below).
manual setting of the network parameter for IPv4.
manual setting of the camera's IP address
manual setting of the camera's subnet mask
manual setting of the camera's gateway IP address (also known as
default router)
Manual: manual allocation of the IPv6 address
DHCP: automatic allocation of the address by the DHCP
Route advertisement:
IPv6 network address
IPv6 Subnet Mask
IPv6 Default Gateway
display of the MAC address
maximum packet length
multicast network address
enable the multicast function
manual setting of the DNS server's IP address
alternative IP address of a DNS server
the default port for HTTP transmission is 80. If several IP cameras are
located on one subnet, each camera should have its own unique HTTP
port.
the default port for RTSP transmission is 554. If several IP cameras
are located on one subnet, each camera should have its own unique
RTSP port.
The default port for HTTPS transmission is 443. If several IP cameras
are located on one subnet, each camera should have its own unique
HTTPS port.
The default port is 8000. If several IP cameras are located on one
subnet, each camera should have its own unique SDK port.
90