Yamaha YRS-2100 Mode D'emploi page 17

The screen below is displayed after connecting
IntelliBeam microphone to the unit.
AUTO SETUP
(PREPARATION & CHECK)
Please connect the MIC.
Please place the MIC at least
1.8m/6ft away from SoundPro-
jector. The MIC should be set
at ear level when seated.
Measurement takes about 3min.
After [ENTER] is pressed,
please leave the room.
[ENTER]:Start [RETURN]:Cancel
Note
The best setting may not be done if you are in the room. Prepare to
leave the room in 10 seconds after pressing
4
Press ENTER key to start the AUTO
SETUP procedure and then leave the room
within 10 seconds.
The setup screen automatically changes during the AUTO
SETUP procedure.
AUTO SETUP START
Will begin in 10 sec.
Please leave the room.
---------
[RETURN]:Cancel
XXXXXXXXSHOW
MEASUREMENT COMPLETE.
BEAM MODE
SUBWOOFER :Yes
[ENTER]:Save set-up.
[RETURN]:Do not save set-up.
If AUTO SETUP procedure is complete, this unit rings
4)
the chimes.
y
4)
• If an error occurs, an error buzzer sounds and an error message is
displayed. For details on error messages, see "Error messages for
AUTO SETUP" (☞p. 15).
• If "ENVIRONMENT CHECK:Failure" is displayed, refer to "Error
messages for AUTO SETUP" (☞p. 15), press
then run the AUTO SETUP procedure again.
• Depending on the environment of your listening room, the beam
angles of front right and left and surround left and right may be set to
the same value even if "BEAM MODE :5 Beam" is displayed as a
result.
1) 2)
ENTER in step 4.
3)
(After 3 min.)
RESULTXXXXXXXXXX
:5Beam/Plus2
RETURN key, and
5
Press ENTER key to confirm the
5)
results.
The measurement result is saved.
AUTO SETUP COMPLETE
Please remove the MIC
from Sound Projector
and the listening position.
6
Remove the IntelliBeam microphone.
6)
Initial screen appears.
Keep the IntelliBeam microphone in a safe place.
The measurement results are stored in the internal
memory of this unit until you run the AUTO SETUP
procedure again or configure the settings manually.
You can save the several measurement result using
memory setting function (☞p. 16).
y
5)
If you do not want to reflect the results, press
y
6)
When AUTO SETUP is performed from SETUP MENU, menu selection
screen of SETUP MENU appears.
Initial settings
RETURN key.
13
En