Fisher & Paykel AquaSmart Guide D'utilisation page 40

Changing pre-set options
US
38
CA
Wash temperature
Controlled Cold
If your incoming cold water temperature is very low you will get a less effective wash. The
CONTROLLED COLD option solves this problem by adding a small amount of hot water to raise
the temperature of the wash to approximately 68°F (20°C).
To programme the CONTROLLED COLD temperature option:
Enter Option Adjustment mode (refer to page 36).
1
Select the HEAVY cycle.
2
Select COLD wash temperature by using the WASH TEMP button (if not already selected).
3
The digital display shows the temperature adjustment possible. The default setting is "tAP",
4
ie the temperature of the incoming water from the cold cylinder.
Touch the MORE
■ ■
washer) so "0" is displayed. Your washer will now control the cold temperature to approximately
68°F (20°C).
Wash Temp
Fig.25 Changing the Cold wash temperature setting to Controlled Cold
Note: if you always use COLD or CONTROLLED COLD water, we recommend that a WARM or
HOT wash be used regularly, eg every 5th wash should be at least a warm one to maintain the
cleanliness of your washer.
button (or the HIGH EFFICIENCY button, depending on your model of
OOB Recovery
EOC Beeps
Factory Reset
Wash Temp
OOB Recovery
EOC Beeps
Factory Reset