Fisher & Paykel Ice & Water E522B Guide D'utilisation page 10

Installation instructions
US
8
CA
Contents of filter kit
13 ft (4 m) white ¼" (6 mm) tubing
1
1 x 8" (200 mm) blue tubing
2
1 x pressure reducing valve (PRV)
3
1 x double sided tape
4
2 x locking keys
5
1 x water filter cartridge and head
6
1 x faucet connection
7
1
Important!
It is imperative the pressure reducing valve (PRV) is fitted prior to the filter. This valve ensures the
■ ■
water will not flow back into the mains from the refrigerator water system. If the PRV is not fitted
to the connection line, the Ice & Water features may not function in some circumstances.
The water connection to your Ice & Water refrigerator must be installed by an authorized
■ ■
plumber or authorized Fisher & Paykel service person.
The water connection instructions below are intended only for the professional installer.
■ ■
The new tubings supplied with the refrigerator are to be used, old tubings from old Ice & Water
■ ■
connections should not be used.
Installation precautions/warning
DO NOT use with water that is microbiologically unsafe or of unknown quality without
■ ■
adequate disinfection before or after the system.
WARNING – connect to potable water supply only.
■ ■
DO NOT install on line pressure above 119 psi (827 kPa) or below 22 psi (150 kPa).
■ ■
DO NOT use on hot water supply (100°F [38°C max.]).
■ ■
DO NOT cut any length of tube shorter than 200 mm.
■ ■
DO NOT install near electrical wires or water pipes that will be in the path of drilling when
■ ■
selecting the location of filter system.
DO NOT mount filter in such a position so that it will be struck by other items, such as
■ ■
wastebaskets, etc.
DO NOT install the filter or any water tubing in direct sunlight as prolonged exposure to light
■ ■
can weaken plastic components.
DO NOT install in a location that is susceptible to freezing temperatures as damage to the
■ ■
housing could occur.
DO NOT screw filter to the refrigerator.
■ ■
DO NOT install the filter or any water tubing in high temperature areas eg in a ceiling cavity.
■ ■
AVOID contamination of pipes during installation.
■ ■
DO NOT use copper tubing. The plastic tubing supplied should always be used.
■ ■
DO NOT continuously dispense water for longer than 2 minutes.
■ ■
2 3
Fig.2 Water connection kit
4 5 6 7