Bresser Tendence Mode D'emploi page 41

selection mode. Press the UP (▲) or DOWN (▼) button to select
the preferred units of measure for pressure: inHG (English), hPa/
mBar (scientifi c) or mmHg (metric)
• Press MEM/ HISTORY to confi rm your selection. Then press MODE
to move to the ALTITUDE unit selection mode. Press the UP (▲) or
DOWN (▼) button to select pressure unit as FEET or METER.
• Press MEM/ HISTORY to confi rm and hold MODE to move to the
ALTITUDE value selection mode.
• Press UP (▲) or DOWN (▼) to select or adjust the altitude value
to your location. (Press and hold either button for accelerated digit
advance)
• Press MODE to confi rm the programming selection.
(NOTE: The unit will automatically exit programming mode if it
does not detect a button press after 2 minutes.)
VIEWING PRESSURE AND ALTITUDE INFORMATION
To view pressure or altitude information, press MODE button. The
display will alternate between the sea level pressure, local pressure and
local altitude screens.
PROGRAMMING SEA LEVEL PRESSURE (not required if you did
altitude)
• Press and hold MODE, until the barometric pressure digits are fl ash-
ing.
• Enter the desired sea level pressure value by pressing UP (▲) or
DOWN (▼) buttons. (Press and hold either button for accelerated
digit advance.)
• Press MODE, to confi rm sea level value selection.
CHANGING PRESSURE AND ALTITUDE UNITS
• Press MODE as needed, until "LOCAL" pressure is displayed.
• Press and hold MEM/ HISTORY, until the pressure unit is fl ashing.
41
GB/IE