Cd Player (Cdx-E410); Remote Control - Yamaha MCR-E410 Mode D'emploi

CD player (CDX-E410)

Problem
Power turns on but The power cable is not connected or the
immediately shuts off. plug is not completely inserted.
Power immediately Auto-standby function of the receiver
shuts off during works when the receiver can not receive
playback. the playing signal transmitted from the
CD player with the system control cable
for 30 minutes.
No sound or distorted The sampling rate of a MP3 or WMA file
sound may not be compatible with the CD
player.
No audio at digital Incorrect digital cable connections.
output
The disc being played back may not be
compatible with the CD player.
Disc playback does You may use a CD-R/RW that is not
not start.
finalized.
The disc label may not be facing up.
The disc may be defective.
MP3/WMA disc may not contain
sufficient music tracks to be played back.
The sampling rate of a MP3 or WMA file
may not be compatible with the CD
player.
The CD player does The disc lens may be dirty.
not read CDs.

Remote control

Problem
The remote control Wrong distance or angle.
does not work nor
function properly.
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
The batteries are weak.
The system control cable is disconnected
from the system connector jack of the
receiver and/or the CD player.
Cause
Connect the power cable firmly.
Check the connection of the system control cable
between the receiver and the CD player.
Check the sampling rate and bit rate of an MP3 or
WMA file are compatible with the CD player.
Connect the digital cables properly.
Check that the disc is compatible with the CD player.
Finalize the CD-R/RW.
Check that the disc label is facing up.
Try to play back another disc. If the same problem
does not happen, the disc you want to play back is
defective.
Check that your MP3/WMA disc contains at least 5
MP3/WMA music files.
Check the sampling rate and bit rate of an MP3 or
WMA file are compatible with the CD player.
Use a lens cleaner to clean the lens.
Cause
The remote control functions within a maximum
range of 6 m (20 ft) and no more than 30 degrees
off-axis from the front panel.
Reposition this system.
Replace all batteries.
Connect the receiver and the CD player with the
system control cable firmly.
Troubleshooting
Remedy
Remedy
See
page
17
12
42
15
42
—
—
—
—
42
42
See
page
11
—
11
12
41
En