Yamaha A-S1000 Mode D'emploi page 11

4 5
MAIN IN PRE OUT
6 AC IN
Use this inlet to plug in the supplied power cable.
7 VOLTAGE SELECTOR
(Asia and General models only)
The VOLTAGE SELECTOR on the rear panel of this unit
must be set for your local main voltage BEFORE plugging
the power cable into the AC wall outlet. Improper setting
of the VOLTAGE SELECTOR may cause damage to this
unit and create a potential fire hazard.
Rotate the VOLTAGE SELECTOR clockwise or
counterclockwise to the correct position using a straight
slot screwdriver.
Voltages are as follows:
............................ AC 110/120/220/230–240 V, 50/60 Hz
1 6
SPEAKERS L CH
A
B
7 8
VOLTAGE SELECTOR
230-
240V
AC IN
8 Foot
If this unit is unstable, you can adjust the foot height by
rotating it.
9 PHONO
Selects the type of magnetic cartridge of the turntable
connected to the PHONO jacks on the rear panel.
• Set to the MM position when the connected turntable has a
moving magnet (MM) cartridge.
• Set to the MC position when the connected turntable has a
moving coil (MC) cartridge.
Note
When you replace the cartridge, be sure to turn off this unit.
11
En