Operation - Okay PCS 5046 Manuel D'utilisation

available, use an antioxidant added quality oil expressly
labeled for air-cooled 2-cycle engine use.
RECOMMENDED MIXING RATIO GASOLINE 40: OIL 1
These engines are certified to operate on unleaded
gasoline.
WARNING
Gasoline is very flammable. Avoid smok-
ing or bringing any flame or sparks near
fuel. Make sure to stop the engine and
allow it cool before refueling the unit. Se-
lect outdoor bare ground for fueling and
move at least 3 m (10 ft) away from the
fueling point before starting the engine.
IMPORTANT
1. FUEL WITH NO OIL (RAW GASOLINE) – It will
cause severe damage to the engine inner parts very
quickly.
2. OIL FOR 4-CYCLE ENGINE USE or WATER
COOLED 2-CYCLE ENGINE USE – It can cause
spark plug fouling, exhaust port blocking, or piston
ring sticking.
How to mix fuel
Mixing table for fuel mixture
Petrol
1 litre
5 litres
1. Measure out the quantities of gasoline and oil to be
mixed.
2. Put some of the gasoline into a clean, approved fuel
container.
3. Pour in all of the oil and agitate well.
4. Pour in the rest of gasoline and agitate again for at
least one minute.
5. Put a clear indication on the outside of the container
to avoid mixing up with gasoline or other containers.
Chain Oil
Use special chain saw oil all year
round.
GB | Operating Instructions
2-stroke oil / 40:1
25 ml
125 ml
NOTE
Do not use waste or regenerated oil that can cause dam-
age to the oil pump.

7. Operation

Starting engine
1. Untwist and remove the fuel and chain oil caps. Rest
the caps on a dustless place.
2. Put fuel into the fuel tank to 80% of the full capacity
and chain oil into the oil tank.
3. Fasten the fuel and oil caps securely and wipe up
any fuel spillage around the unit.
4. Put the switch to the "I" position.
3) Engine switch
5. Continuously push the priming bulb (x) until fuel
comes in the bulb.
6. Pull out the choke knob. The choke will close and the
throttle lever will then be set in the starting position.
8
1) Oil
2) Fuel
or