Okay PCS 5046 Manuel D'utilisation page 69

3. Guide bar
When the guide bar is dismounted, remove sawdust
in the bar groove and the oiling port. Grease the nose
sprocket from the feeding port on the tip of the bar.
4. Others
Check for fuel leakage and loose fastenings and dam-
age to major parts, especially handle joints and guide
bar mounting. If any defects are found, make sure to
have them repaired before operating again.
Periodical service points
1. Cylinder fins
Dust clogging between the cylinder fins will cause
overheating of the engine. Periodically check and clean
the cylinder fins after removing the air cleaner and the
cylinder cover. When installing the cylinder cover, make
sure that switch wires and grommets are positioned cor-
rectly in place.
GB | Operating Instructions
1) Oiling port
2. Fuel filter
a) Using a wire hook, take out the filter from the filler port.
1) Oiling port
2) Grease port
3) Sprocket
b) Disassemble the filter and wash with gasoline, or
• After removing the filter, use a pinch to hold the end
• When assembling the filter, take care not to allow filter
3. Oil tank
With a wire hook, take out the oil filter through the filler
port and clean in gasoline. When putting the filter back
into the tank, make sure that it comes to the front right
corner. Also clean off dirt in the tank.
13
replace with a new one if needed.
IMPORTANT
of the suction pipe.
fibers or dust inside the suction pipe.
1) Fuel filter
2) Oil filter