Edirol AudioCapture UA-1A Mode D'emploi page 10

Connections and driver installation (Windows)
Making connections and installing the driver
Windows Me Users
* If you are using a Windows 2000 machine, refer to p. 11, if
Windows 98, refer to p. 11.
1
Turn on the power of your computer and start up
Windows, and use a USB cable to connect the UA-1A
to your computer.
fig.02-03.e
2
When Windows detects
the UA-1A and the Add
New Hardware Wizard
dialog box appears, make
sure "Automatic search
for a better driver
(Recommended)" is
selected, then click [Next].
3
The search for the driver starts.
4
When the correct driver is found, driver installation
starts.
fig.02-04.e
5
When a dialog box
informing you that driver
installation has finished
appears, click [Finish], and
restart Windows.
After installing the driver,
refer to Specifying the audio
input/output device (p. 14) and select the device Windows
uses.
* Depending on your computing setup, there may be a short wait after
the driver is installed until the device is recognized.
10
Some time may be required
until this dialog box appears.