Options - Cristec CPS2 Serie Manuel D'utilisation

4.2.6 Options

The options are not bundled with standard CPS2 shore-power units; they are available from your
reseller. Only options marketed by Cristec may be mounted with shore-power units.
The following options are available for the CPS2 range:
Remote On/Off charger control: reference A/M-CPS2
A 5-metre cable + On/Off switch; connect to K8 connector (see drawing in appendix)
Remote Boost control: reference BAD-CPS2
A 5-metre cable + Boost On/Off switch; connect to K11 (see drawing in appendix)
Temperature probe: reference STP-CPS2
Compensates the charging voltage according to temperature
12V Charger: -18mV/°C
A 5-metre cable + probe; connect to K2 (see attached drawing)
Digital display unit: reference SEEL009104
Displays the state of the charger (ON/OFF), the current of the charger, the voltage on each of the 3
outputs and the rate of battery charge.
A 10-metre cable + display unit; connect to K3
Cables for analogue display units: reference DEP-V-A-CPS2
For connecting analogue voltmeter options (1 to 4 depending on the number of outputs to be
monitored: Bat D, Bat 1, Bat 2 or the voltage upstream of the distributor) and an ammeter
A 5-meter cable; connect to K10 (see drawing in appendix)
48x48mm analogue voltmeter to view the voltage of a particular output or the charger's voltage
upstream of the distributor
Reference: VLT0012-CPS2 for 12Vcc chargers
Connect to K10 with option DEP-V-A-CPS2
48x48mm analogue voltmeter to view the charger's total current; connect to K10 with option
DEP-V-A-CPS2
Model
CPS2/12-16
CPS2/12-25
CPS2/12-40
Remote LEDs option: reference LED-DEP-CPS2
A 5-metre cable to connect on KLD1/KLD2/KLD3
UECPS2-12-16/25/40-DEA.DOC
Reference
AMP 12V/16A CPS2
AMP 12V/25A CPS2
AMP 12V/40A CPS2
29