Connecting To A Computer - Sony BRAVIA VPL-VW70 Mode D'emploi

Connecting to a Computer

Right side of the projector
HD-Dsub15 pin cable (not supplied) or HDMI cable (not supplied)
: Video signal flow
Tip
When connecting an HD-Dsub15 pin cable, set "Input-A Signal Sel." in the Setup
"Auto" or "Computer." If the input signal does not appear properly, set it to "Computer." (1
pages 53, 66)
Notes
• When connecting an HDMI cable, make sure the
input of the projector and the
position.
• If you set your computer, such as a notebook type, to output the signal to both
computer's display and this equipment, the picture of the equipment may not appear
properly. Set your computer to output the signal to only the external monitor.
For details, refer to the computer's operating instructions supplied with your computer.
For settings of the computer, consult with the manufacturer of the computer.
• If the picture from equipment connected to the projector with an HDMI cable is not
clear, check the settings of the connected equipment.
20
GB
When using an optional HDMI cable, be sure to use
a cable that has acquired the HDMI logo.
V
mark on the connector of the cable is set at the same
v
Computer
to monitor output
mark on the upper part of the HDMI
menu to