Preparing The Flash Unit For Use; Mounting The Flash Unit - Metz mecablitz 26 AF-2 Mode D'emploi

26AF-2 Sony
• Flash-ready indication in camera viewfinder/
camera display
• Automatic fill-in flash control
• Preflash TTL and ADI metering
• Automatic fill-in flash control
• Manual flash exposure correction
• /1st or 2nd curtain synchronisation (REAR)
(set on the camera if possible)
• AF auxiliary light control (set on the camera if possible)
• Wireless remote slave TTL/M flash mode (set on the
camera if possible)
• Programmed auto flash mode
• Wake-up function for the flash unit
It is impossible to describe all camera types and their
individual dedicated flash functions within the scope of
these instructions. Therefore, please refer to the flash
mode description in your camera's operating instruc-
tions to find out which functions are supported and
which ones have to be set manually on the camera.
Using lenses not equipped with a CPU (i.e., lenses
without auto focus mode), results in certain functional
limitations!

3 Preparing the flash unit for use

3.1 Mounting the flash unit

Mounting the flash unit on the camera
Turn off the camera and flash before mounting or
removing.
• Press and Locking button
cap on Sony) and slide the flash unit, together with
the connection base, into the camera's hot shoe as far
as possible.
• Release Locking button
locked.
In camera housings which have no locking hole, the
spring-loaded locking pin retracts into the housing of
the flash unit to avoid damage to the surface.
(Remove the protective
– the flash unit is now
k
89