Speaker Setup Guide; Safety Precautions When Setting Up; Home Theater Sound Setup; Standard Surround Setup - Pioneer HTS-GS1 Mode D'emploi

Speaker Setup Guide

Chapter 1
Speaker Setup Guide

Safety precautions when setting up

When assembling the speakers, lay them down flat on
their side to avoid accidents or injury. Make sure to use a
stable surface when assembling, setting up, and placing
the speakers.
• Attach the smaller non-skid pads to the base of each
of the front speakers and the center speaker. The four
large non-skid pads are for the receiver subwoofer (as
shown).
Use the supplied adhesive to attach 4 pads to the base
(flat surface) of each speaker.
Non-skid pads
(small) x 12
Front speakers
Non-skid pads
(large) x 4
Center speaker
Receiver subwoofer

Home theater sound setup

Depending on the size and characteristics of your room,
you can place your speakers in one of two ways using this
system:

Standard surround setup

This is a standard multichannel surround sound speaker
setup for optimal 5.1 channel home theater sound. Use
this setup together with Auto listening mode on page 19
or other listening mode.
Front
left
Surround
left
Listening position
• Connect the speaker system.
Refer to Connecting up to connect the speakers properly.
After connecting everything, place the speakers as
shown in the diagram (above) for optimal surround
sound.
After placing the speakers, run the Auto MCACC setup
(page 17) to complete your surround sound setup.
Front
right
Center
Receiver subwoofer
Surround
right
01
7
En