Ice Maker Installation; Unpacking - Summit BIM44 G Mode D'emploi

Unpacking

Use two or more people to move and install ice maker.
Failure to do so can result in back or other injury.
Remove packaging materials.
IMPORTANT: Do not remove any permanent instruction labels or the data label on
your ice maker.
Remove tape and glue from your ice maker before using.
To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or
glue residue can also be easily removed by rubbing a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water and dry.
Do not use sharp instruments, rubbing alcohol, flammable fluids or abrasive cleaners to
remove tape or glue. These products can damage the surface of your ice maker.
Water supply hose

ICE MAKER INSTALLATION

Excessive Weight Hazard
Ice scoop
Drain hose
7
Power cord
Water inlet
Drain outlet