Condenser Cleaning - Summit BIM44 G Mode D'emploi

2. Open the door and take out the removable ice storage bin. With a clean cloth, wipe
down the interior of unit and ice bin with a sanitizing solution made of 1 ounce of
household bleach or chlorine and 2 gallons of hot (95ºF – 115ºF) water.
3. Pull off the drain hose of the water trough to drain off all water.
4. Rinse thoroughly with clear water.
5. After draining off all water, put back the drain hose of the water
trough into the original location.
6. Put the ice storage bin inside the unit.
7. Reconnect power to the unit.
The ice scoop should be washed regularly. Wash it just like any
other food container.
DO NOT use solvent-based cleaning agents or abrasives on the interior.
These cleaners may transmit taste to the ice cubes
discolor the interior.

Condenser cleaning

A dirty or clogged condenser prevents proper airflow, reduces ice making capacity, and
causes higher than recommended operating temperatures that may lead to component
failure. Have the condenser cleaned at least once every six months.
Unplug the ice maker or disconnect power.
1.
Gently pull off the lower front louver.
2.
Remove dirt and lint from the condenser and the
3.
unit compartment with the brush attachment of a
vacuum cleaner.
Reassemble the lower front louver.
4.
Plug in the ice maker or reconnect power.
5.
DO NOT touch the condenser.
Correct location of
the drain hose
Edges are sharp and can be easily damaged.
22
and damage or
Condenser
Surface