Summit BIM44 G Mode D'emploi page 5

ordinances, is required.
Do not kink or pinch the power supply cord between the ice maker and cabinet.
The fuse (or circuit breaker) size should be 15 amperes.
It is important for the ice maker to be leveled in order to work properly. Otherwise water
may not flow properly through the evaporator (ice mold). The ice production will be less
than normal. You may need to make several adjustments to level it.
All installations must be in accordance with local plumbing code requirements.
Make certain that hoses are not pinched, kinked or damaged during installation.
Check for leaks after water line is connected.
Although the unit has been tested and cleaned at the factory, due to long-term transit and
storage, the first batch of cubes must be discarded.
Remove the packing materials and clean the ice maker before using.
Turn on the water supply tap before switching on the ice maker. Never turn the water
supply tap off when the ice maker is working.
Except to take ice from the unit, keep the door closed in order to reduce ice melting and
to promote proper ice formation.
If the ice maker will not be used for a long time, before the next use it must be
thoroughly cleaned. Follow carefully any instructions provided for cleaning or use of
sanitizing solution. Do not leave any solution inside the ice maker after cleaning.
Do not touch the condenser fins. They are sharp and can be easily damaged.
DO NOT use solvent-based cleaning agents or abrasives on the interior. These cleaners
may transmit taste to the ice cubes, or damage or discolor the interior.
The ice machine cleaner contains acids. Do not use or mix with any other solvent-based
cleaning products. Use rubber gloves to protect hands. Carefully read the safety
instructions on the container of the ice machine cleaner.
Do not use the apparatus other than for its intended purpose.
Electrical Connection
Do not, under any circumstances, cut or remove the third (ground) prong from the power
cord. For personal safety, this appliance must be properly grounded. The power cord of
this appliance is equipped with a 3-prong grounding plug that mates with a standard 3-
prong grounding wall outlet to minimize the possibility of electric shock hazard from the
appliance. Have the wall outlet and circuit checked by a qualified electrician to make sure
the outlet is properly grounded. When a standard 2-prong wall outlet is encountered, it is
your responsibility and obligation to have it replaced with a properly grounded 3-prong
wall outlet. The ice maker should always be plugged into its own individual electrical
outlet which has a voltage rating that matches the rating label on the appliance. This
provides the best performance and also prevents overloading house wiring circuits which
could cause a fire hazard from overheated wires. Never unplug your ice maker by pulling
on the power cord. Always grip the plug firmly and pull straight out from the outlet.
Repair or replace immediately all power cords that have become frayed or otherwise
damaged. Do not use a cord that shows cracks or abrasion damage along its length or at
either end. When moving the ice maker, be careful not to damage the power cord.
SAVE THESE INSTRUCTIONS
4