Summit BIM44 G Mode D'emploi page 29

Cubes are partially
formed or are white
on the bottom.
Noise during
operation
The ice maker stops
suddenly while
making ice.
The body of the ice
maker is electrified.
Scaling occurs
frequently inside
the machine.
Water leaks from
the ice storage bin
Buzzer alarm
Not enough water in the
water trough.
The feet are not leveled and
locked.
Certain sounds are normal.
The electricity is off.
The room temperature is out
of the stated range.
The ice storage bin is full of
ice.
The ground line isn't in the
socket.
The hardness level of the
water is too high.
The drainhole below the ice
storage bin is blocked.
The drain hose is kinked or
improperly placed higher
than the floor of the ice
storage bin.
Problem in pumping out
water
Check if the water supply pressure is below
15 psig.
Check water supply or filter may be
restricted.
Check for a water leak at the water trough.
Level and lock the feet. See Leveling the Ice
Maker.
See Normal Sounds.
Reconnect the power supply line.
Cut off the electricity and leave the ice
maker disconnected until the temperature
returns to within the stated range.
Remove some ice cubes; make sure the
ice-full probe is free of ice.
Use a socket meeting the grounding
requirements.
Install a water-softening device in front of
the water inlet.
Remove the ice storage bin and clean the
drainhole.
Check the drain hose to be sure water can
be drained out unhindered.
Check for correct operation of drain water
pump, water level switch and drain tube.
28