Changing the strap
You may change the strap attached to the Leap Ware.
Open the spring latch at the top of both straps to remove the old strap.
1. Slide one end of the spring
bar of the new strap into the
hole in the watch body.
2. Use the latch to retract the pin
on the spring bar.
3. Slide the strap into position
and release the latch so the
strap locks into place.
4. Repeat for the second part of
the strap.
Care and wearing tips
• When using the flashlight, wear the device on your left wrist.
• Position the Leap Ware so the strap is two finger-
widths from the base of your palm. The face should
be a short distance from your wrist bone (ulna).
• To improve the accuracy of readings, attach the strap
tightly, so the pads on the underside of the Leap
Ware are held firmly against your wrist.
• Do not submerge the Leap Ware or wear while
swimming.
• If you notice any signs of skin irritation or experience any discomfort,
please remove or move the Leap Ware until your skin recovers.
Important
The Leap Wear is not a medical device. Readings taken by the
Leap Ware are to promote a healthy lifestyle, and should not be
used or relied on as a medical device to diagnose any medical
condition or symptom.
Consult a physician before beginning any fitness program.
1
2
Setting up - 7
3