Toshiba RAV-SM562KRT-E Manuel D'installation page 18

8
TEST RUN
In case of wired remote controller
Procedure
TEST
Keep button pushed for 4 seconds or more.
1
[TEST] is displayed on the display part and the selection of mode in the test mode is
permitted.
ON / OFF
2
Push
MODE
Using
• Do not run the air conditioner in a mode other than [COOL] or [HEAT].
3
• The temperature controlling function does not work during test operation.
• The detection of error is performed as usual.
After the test operation, push
4
(Display part is same as procedure 1.)
TEST
Push button to cancel (release from) the test operation mode.
5
([TEST] disappears on the display part and the status returns to a normal
stop status.)
9
TROUBLESHOOTING
Incase of wired remote controller
Confirmation and check
When a trouble occurred in the air conditioner, the
check code and the indoor unit No. appear on the
display part of the remote controller.
The check code is only displayed during the operation.
If the display disappears, operate the air conditioner
according to the following "Confirmation of error history"
for confirmation.
EN
TEMP.
FILTER
RESET TEST
1, 5
button.
button, select the operation mode, [COOL] or [HEAT].
ON / OFF
button to stop the operation.
ON / OFF
2, 4
TIMER SET FAN MODE
TIME SWING/FIX VENT
SET CL UNIT
Description
15
3
TEST
UNIT No.
R.C. No.
Check code Indoor unit No. in which
an error occurred
CODE No.