MTS ATLAS Guide D'utilisation page 21

The MTS key blinks twice. You have
4.
successfully changed the gateway ID in your
remote.
Sending the Gateway ID to the Set-top Box
1. Turn on your television and set-top box.
2. Press MTS once. Then press and hold SETUP
until the MTS key blinks twice.
Press A. This sends the new ID to the set-top
3.
box. The set-top box displays a message
indicating that the ID has been changed. For
example, if you changed the ID from 000 to
111, the set-top box displays "The gateway ID
has changed from 000 to 111" on your TV.
NOTE: If you press A but did not change the ID num-
ber, the set-top box displays a message indi-
cating that the ID was already set to that
number, for example, "The gateway ID was
already set to 001. "
Checking the Set-top Box's Gateway ID
To check the set-top box's gateway ID, perform the
following steps:
1. Turn on your TV and set-top box.
2. Press MTS once. Press and hold SETUP until
the MTS key blinks twice.
Press B. The set-top box displays the current
3.
ID. For example, if the current ID is 001, the
set-top box displays "The remote gateway ID
is 001, the RG gateway ID is 001. "
NOTE: If the remote's gateway ID and the set-top
box's ID are not identical, the remote does not
operate the set-top box while in RF mode
(remote ID 1, 2, or 3).
21