Checking Your Remote's Id Code - MTS ATLAS Guide D'utilisation

NOTE:
Only one device can be assigned to an unused
device key at a time.
To Re-Assign
AUX as 2nd
AUD key
AUX as 2nd
TV key
AUX as 2nd
MTS key
AUX back to
AUX
To re-assign another unused device key, substitute it for
the AUX key above and then perform the sequence. For
example, to re-assign an unused AUD key as a second
DVD key, perform
AUD SETUP 9 9 2 DVD AUD.
When a re-assignment is done, the selected device key
(e.g., AUD) blinks twice to confirm your choice. At that
time, you need to program device control (see
"Programming Device Control" on page 9).

CHECKING YOUR REMOTE'S ID CODE

In order to use your Atlas DVR/PVR IR/UHF Remote's
RF functions, the remote must have an ID code of 1, 2,
or 3. In order to control your MTS Set-top Box using IR,
your remote must have an ID code of 0. To check your
remote's ID code, perform the following steps:
Press MTS once. Then press and hold SETUP
1.
until MTS blinks twice.
'
2. Enter 9 5 6.
3. Press 1 once. Count the number of times the
MTS key blinks (e.g., 3 blinks = 3). The
number of blinks is your remote's ID code.
Perform Key Sequence
AUX SETUP 9 9 2 AUD AUX
AUX SETUP 9 9 2 TV AUX
AUX SETUP 9 9 2 MTS AUX
AUX SETUP 9 9 2 AUX AUX
19